View Single Post
jonesb930 jonesb930 is offline
Drive it like u stole it.
 
jonesb930's Avatar
 
Join Date: May 2003
Location: Jupiter, FL
Posts: 530
Garage
I just did this last weekend. Take a look at Figure 6-9 on page 159. Make sure you are going down the access hole to measure from the front flange to the intermediate shaft gear face.

First measure the thickness of your strait edge, write this down.

Next measure the distance from the front flange to the intermediate shaft gear face (down the hole) and write this down.

Add the thickness of the strait edge to the flange to intermediate shaft front gear measurement. This is now your reference measurement!

Now you have the desired measurement of the right side gear face (should be very close to your reference measurement). The right side should line up with the intermediate shaft gear face within .25mm

Now measure the left side. Write this down than subtract 54.8mm from this measurement. It should be within .25mm of your intermediate shaft measurement.
__________________
____________________________
Bill Jones
Jupiter, FL
77 Euro 911 3.0 Wide Body - under construction
http://www.flickr.com/photos/rennsport/collections/72157618856489537/

Last edited by jonesb930; 05-20-2010 at 07:16 PM..
Old 05-20-2010, 07:13 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #4 (permalink)