View Single Post
grizzfan grizzfan is offline
Registered
 
Join Date: May 2010
Location: Big Sky Country
Posts: 813
Garage
Your prayers helped but this is driving me nuts!!!

The car rode up on the 10'x2's very nicely. (I had stapled some of that rubber cupboard liner material from the Dollar Store on the bottom to lessen slipping). But now I couldn't get the floor jack under the lifting point without putting the front wheels of the jack up on the boards.

Front floor stand went under just fine but the rear torsion bar jackstand location is about half way across the board. I could put another couple of pieces of wood right next to it, but one really need to remove the boards after the car is jacked up.

A 12" board that JJ suggests would have only made matters worse for my setup. JJ just needs to raise the car a few inches to get his sissors jack underneath.

What am I missing here?!

Tom
Old 07-10-2010, 11:31 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #26 (permalink)