View Single Post
Eagledriver Eagledriver is offline
Registered User
 
Join Date: May 2003
Posts: 3,231
I don't understand why you would need or want clearance between the wrist pin and the piston. The bearing surface for this part is the small end of the connecting rod. This is where you need clearance. As long as the fit in the piston is not so tight as to crack the piston or be too difficult to install/remove then a tight fit is good.

-Andy
__________________
72 Carrera RS replica, Spec 911 racer
Old 09-09-2010, 07:19 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #11 (permalink)