View Single Post
Tilikum Turbo Tilikum Turbo is offline
Registered User
 
Tilikum Turbo's Avatar
 
Join Date: May 2010
Location: Los Angeles
Posts: 1,004
Garage
Superheated air for the factory set-up?

Quote:
Originally Posted by aerodyn930 View Post
Aluninum sheeting along with rtv sealant would work fine, close up all the openings, Check the area in front of the engine as this can be a 1" gap that runs full width of the engine compartment , Get under the car and look up in that area, Most cars show this defect. We use high density foam to seal this gap , Also behind the engine the rubber seal is usually destroyed by heat, replace with high temp silicone material,



Intercooler mist systems can be used to restore some efficiency , There are some very good kits out there, As you continue your search for better Intercooling consider a temp. instrument (in/out),

Good luck with your project, Lou / AERO DYNAMICS
While I do agree that as much air is to be forced through the intercooler, but when the system is completely sealed, isn't what's going into the engine's intake superheated air from the engine AND intercooler?
__________________
1983 911 3.3L Turbo(YES, I know the turbo badge is on the right...had to be different!)
1996 Toyota Corolla(der 'clapper')
Old 09-26-2010, 01:51 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #20 (permalink)