View Single Post
full quack full quack is offline
Registered User
 
full quack's Avatar
 
Join Date: Apr 2007
Location: Seattle-ish
Posts: 1,128
Send a message via Yahoo to full quack
Yeh, with the right tools (i.e. a big torch) the job would be soooo much easier!
I was a little concerned about too much heat on the machined splines, as I suspect they are heat treated, but I could be all wet here.
Mark
Old 10-20-2010, 09:45 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #11 (permalink)