View Single Post
WANNA930 WANNA930 is offline
Registered User
 
Join Date: May 2008
Posts: 422
An easy way to remove rubber bushing is with a simple drill. Drill a couple say 3/16's holes through the rubber near the actual sleeve. If you apply pressure to the bit it will start to walk itself around the rubber between the sleeve. Sometimes the rubber will actual walk itself out. Takes some work but no fancy tools needed.

I used to a lot of GM stuff and could get a stuck bushing out in 2 minutes using the above no matter how big or stuck.

If it gives difficulty simply drill a few more holes till she pops out. I hate the torch method as it is a mess and stinks the place up.
Old 10-20-2010, 01:34 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #13 (permalink)