View Single Post
jsveb jsveb is offline
Registered User
 
jsveb's Avatar
 
Join Date: May 2007
Location: Norseman territory
Posts: 2,796
Garage
New BL-WUR initial adjustments

Goodmorning

I have just had a WUR modified by Brian Leask.

I installed it and checked the CP according to the Fac. manual. The control pressures was too low ( by .3-.4)

My engine is a 3.5 litre ANDIAL. I had given the data to Brian before he modified the WUR.

My questions is towards whether I have done the right thing by adjusting it.

The temp was 17.5 degrees (approx. )

I adjusted the Cold CP (CCP) to 1.55 bar this is just in the lower end of the specs according to the Fac. man. I did this because I have (not yet) a way of checking AFR, and it is a 3.5 not a 3.3 hence it might need a little more fuel.

I might mention that I drove it for a couple of days with the BL WUR just out of the box. It did not start/drive better then the stock WUR.
I have not driven after I made the adjustments -baby sitting (out in the garage )

I checked the warm CP it was 3.68bar -which is pretty much right on the money.

What do you think? (CP settings etc.)

Thank you

Jesper

Last edited by jsveb; 11-13-2010 at 07:49 AM.. Reason: spelling
Old 11-13-2010, 07:48 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)