View Single Post
nocarrier nocarrier is offline
Registered User
 
Join Date: Mar 2008
Posts: 912
I then used a cut off disk to remove the barbed section of metal line as well as the stop collar on the hard line.

After some trial fits on my Carrera manifold, I decided not to part off the threads of the -an fitting. Instead I turned the threads off leaving sort of an extension that I would braze to the end of the fuel line.

I ended up using argon to purge the lines while brazing and was able to repeat my results I had last night.

Here is the finished -an fitting on the Carrera Line.


Last edited by nocarrier; 06-09-2011 at 06:10 PM..
Old 06-09-2011, 06:07 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #14 (permalink)