View Single Post
JFairman JFairman is offline
Registered User
 
Join Date: Jul 2006
Location: S. Florida
Posts: 7,267
set the stuff back to where it runs best.

to stop the run on permanently unplug the ignition delay relay and cross or jump the 2 wires in it's 4 pin plug that are closest to the motors fan housing.
they are both red wires with a white stripe and one is thicker than the other.

i jumped the 2 wires, left the plug to hang out under the relay panel, and put the delay relay back where it goes with no wires or plug going to it.

stumbling uneven run on will be a thing of the past and you will forget that embarresing annoyance that has to be bad for the crankshaft and rod bearings because oil pressure is so low when it does that... soon.
Old 07-13-2011, 04:59 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #15 (permalink)