View Single Post
overkill overkill is offline
Registered User
 
overkill's Avatar
 
Join Date: Dec 2001
Location: New Jersey
Posts: 2,093
Send a message via AIM to overkill
Thanks AE

Check it out,... after reading the manual over and over and over, I still dont get it!!! I'm only joking I think I understand what the germans are trying to say,... In english,... install camshafts with cylinder 1 lobes facing up. When setting the timing cylinder 4 lobes are facing down. It makes so much sense to me right now. I'll explain,...

Basically, all I have to do now is rotate the cams so that cylinder four lobes are facing up. Once I have them facing up I will spend the time and align the 2 cams perfectly again. They use dial gauges but that to me is a crock of ****. Once i have the cams aligned with cylinder 4 lobes facing up, I then should be able to line up the mark on the gear with the housing therefore allowing me to view the mark through the housing hole. I have to go test this theory of mine brb,...
__________________
{1987}944S - (SOLD).
Old 12-08-2002, 02:08 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #18 (permalink)