View Single Post
Mike Hall Mike Hall is offline
Registered User
 
Join Date: Aug 2004
Location: Leesburg, GA
Posts: 389
Send a message via AIM to Mike Hall
Are there issues with using NA 964 heads for this setup?

For an engine like this would a LWF be idea or just a standard dual mass flywheel?

I am about to go nuts trying to figure out what all would be needed to do for a DME or stand alone ECU. I wouldn't mind trying a MSIII but, I still have a crap pile of reading to do to see if I want to tackle that or not. I assume you have to create base maps to just get the engine running then tune from there? What are the chances you can get the car tuned good enough to drive a bit before getting dyno work done? I am questioning if the MSIII setup would be a wise choice or not as it looks like to get all the components would put its cost up close to a full on stand alone unit like AEM. Any info on this subject to make my choices easier would be awesome.

Mike
Old 10-14-2011, 09:59 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #7 (permalink)