View Single Post
911nut 911nut is offline
Metal Guru
911nut's Avatar
Join Date: May 2001
Location: Michigan
Posts: 2,511
You will need:
(1) One pair of C2/C4 trailing arms
(2) One pair of C2 half shafts
(3) A C2 sway bar

Looking at the PET, it appears that C2 and C4 arms were common but half shafts were not. Also the C2 sway bars were a little bigger in diameter than the C4 sway bar. The rear axle struts (where you would adjust camber and toe) are also common.

Last I heard the going rate for these parts from dismantlers was $1000.
Paul B.
'91 964 Turbo
Port matched, SC cams, K27/K29 turbo, Roush Performance custom headers w/Tial MV-S dual wastegates, Rarlyl8 muffler, LWFW, GT2 clutch & PP, BL wur, factory RS shifter, RS mounts, FVD timing mod, Big Reds, - 210 lb

Last edited by 911nut; 11-16-2011 at 02:03 PM..
Old 11-16-2011, 01:50 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #2 (permalink)