BTW Here is what Barry from SDS sent me for changing from °F to °C (Did not yet):
EM –3/EM-4 SETUP MODE TEMPS
Unplug hall sensor plug from ECU.
Power up the ECU with the programmer plugged in.
Momentarily ( ½ second ) short out pins 6 & 7 on the hall plug port on the ECU using a wire or setup tool (provided by SDS ). See drawing below.
You will see SETUP TEMPSENSOR in the programmer window.
Choose one of the following by pushing the +1 button until the correct sensor is reading in the window.
GM°F
DALE °F
FORD °F
GM/CHT °F
BOSCH °F
CHT/BO °F
GM °C
DALE °C
FORD °C
GM/CHT °C
BOSCH °C
CHT/BO °C <<<<<
Push +10 to exit setup mode
__________________
Roland
930 Turbo '81 Too many modifications to list
|