View Single Post
JFairman JFairman is offline
Registered User
Join Date: Jul 2006
Location: S. Florida
Posts: 7,289
Someone already cut the crimp off the fitting for you.
I've replaced low pressure oil hoses like that on my own car with earls or aeroquip 16AN stainless braided hose.

Wrap the hose tight with masking tape and cut it off nice and straight with a death wheel on a die grinder so the braided end stays together and is cut off straight and clean.

Slide on one of these T-bolt clamps whichever one fits the hose you use.
Heavy-Duty Bridge Opening T-Bolt Hose Clamps - Bolt Clamps |
Heavy-Duty Bridge Opening T-Bolt Hose Clamps - Bolt Clamps |

Push the hose on the barbed fitting, unwrap the tape, slide the clamp over to the cut end so the sharp edges are just covered flush, tighten T-bolt clamps and it won't come loose or leak and it looks nice.

Any high temp 7/8" ID oil hose would work there.
Old 04-30-2012, 05:15 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #14 (permalink)