View Single Post
Uncle Uncle is offline
Bad LT
 
Uncle's Avatar
 
Join Date: Dec 2008
Location: Newcastle Australia
Posts: 657
Anyways more work has gone on.
Fitted dry sump tank breather cap.


Cut 930 size hole in the deck lid then make up some extra spars to stiffen it up a little. Intercoolers make for good beer stands.


Looking at the spars they will make for a great place to run some water/meth sprayers later on.


Oil pump bracket V2.1


Pulled the turbo off and fitted rear engine tin with a new hole for intercooler pipe. While it was out I pulled the cold side housing clip off and rotated it so the oil drain is not 100% vertical rather than the slight tilt it was on.
__________________
3.3 with ported heads,964 cams,3.2 manifold, Haltech EFI,WTA intercooler,BW366,Fabspeed headers,TIAL gate and ARP studs other than that it's completly stock.

Last edited by Uncle; 05-16-2013 at 04:20 AM..
Old 05-16-2013, 04:05 AM
  Pelican Parts Technical Article Directory    Reply With Quote #34 (permalink)