View Single Post
drew1 drew1 is offline
Registered User
 
Join Date: Jul 2000
Location: greenwood,sc usa
Posts: 2,383
If gas cranks it after mashing the flapper, it is probably good enough gas to crank cold.

If no gas comes out the screw hole in the accumulator, check the 5th injector. It is toward the firewall on the manifold.

Ohm it out, if circuit open, it's bad. With the 5th injecvtor pointed into a container to catch the gas, have somebody crank the motor over. You should get spray.

If you don't, then unplug the 5th injector. Put a test light or volt meter accross the injector wire terminals. Crank again. You should have volts initially for up to 10 or 12 sec. If it doesn't then either you are not getting the 12V from the solenoid or thermo switch is bad & not grounding the injector coil.

hope this helps.

Thermo switch is kind of under distributor on the hose housing on back of head.


drew1
Old 03-27-2003, 06:41 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #6 (permalink)