Thread: Sensor Question
View Single Post
awilson40 awilson40 is offline
Registered User
 
Join Date: Aug 2000
Location: North Carolina
Posts: 302
That copper brade is the shielding, It shouldnt read any voltage. When disconnected from the DME its not connected to anything. When plugged in, its shunted to ground. Any yes...most CO's use shielded wire on O2 wire where it might run near an EMF source. This is a very low level signal and you dont want to pick up noise.
__________________
1988 951 Alpine White / Burgandy
Profec B spec II EBC,HomeBrew Chips, WideFire HG, Tial 38mm, Magnecor Wires, Koni Rears, Adj Rear Droplinks, Zeitronix WideBand.
Old 04-07-2003, 10:06 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #4 (permalink)