View Single Post
Jim2 Jim2 is offline
7.0:1 > 11.3:1
 
Join Date: Oct 2003
Location: Calgary
Posts: 1,844
Garage
Robby, it can take a while to prime the cis injection system after it has been apart. Air in the metal injector lines between the fuel head and the injectors. You can crack the nuts loose on all six injectors then with the ignition on, push the metering door down with your fingers until you see a bit of fuel come out from the injector nuts. Shutdown, then tighten the injector nuts back up.

Look after ensuring all lines are hooked up first per Ronnies advice above.

Good to see you so far along. It was just a few weeks ago when you were asking questions about how to do this intercooler/manifold conversion.
Old 03-06-2014, 07:50 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #5 (permalink)