View Single Post
nocarrier nocarrier is offline
Registered User
 
Join Date: Mar 2008
Posts: 930
My 4" cold air intake plumbing project.

Since I've seen a couple of people on here looking at solutions for cold air intake piping I though I would share how I did it.

First thing I needed to do was to make sure the turbo was located exactly where I wanted and held firmly in place. So I whipped up a quick turbo support bracket. I used longer studs threaded into the case. Because of this I had to use spacers between the bracket and turbo in order to remove the bracket without removing the studs.

Last edited by nocarrier; 03-16-2014 at 10:51 AM..
Old 03-16-2014, 10:49 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)