View Single Post
TurboKraft TurboKraft is offline
Registered User
 
TurboKraft's Avatar
 
Join Date: Mar 2005
Location: Phoenix, AZ
Posts: 2,556
Quote:
If your aluminum injector blocks are the same thickness top to bottom as the original plastic injector blocks and then add 10mm for the heat insulator and extra intake manifold gasket with it, do you use 10mm longer intake manifold studs or just thread them into the intake manifold about 10mm less with red loctite?

Also, if you used longer studs to keep the same amount of thread engagement in the flat 930 intake manifold, where did you get them?

Chris, if you see my question here I'd like to hear your opinion on this too.

thanks.
JFairman,
TK's billet CIS injector blocks + insulators combined are the same overall installed height as the stock plastic injector blocks.
Same for our v2.0 EFI Injector Blocks (ex: 5.7GT1's build).
__________________
Chris Carroll
TurboKraft, Inc.
Tel. 480.969.0911
email: info@turbokraft.com
http://www.facebook.com/TurboKraft - http://www.instagram.com/TurboKraft
Old 04-07-2014, 10:35 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #5 (permalink)