View Single Post
JFairman JFairman is offline
Registered User
Join Date: Jul 2006
Location: S. Florida
Posts: 7,289
Hi Chris, I'm out of money to spend on putting this thing back together. A machine shop around here would not be low cost to do that to 6 injector blocks.

Is it possible to just thread them into the heads a little less without ripping the threads out? Or go gasketless with hondabond 4 sealent and wavy washerless and then green loctite the nuts and screw them on just enough so the tops f the nuts are flush with the top end of the stud?

What bad heat soak problems into the CIS injectors will I experience if I go without the heat inulators and just use the thicker than stock gaskets I have?

No one has ever actually said what will the problem(s) you will experience actually be.
Old 04-07-2014, 12:39 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #8 (permalink)