View Single Post
full quack full quack is offline
Registered User
 
full quack's Avatar
 
Join Date: Apr 2007
Location: Seattle-ish
Posts: 1,080
Send a message via Yahoo to full quack
I'll try to accomodate....

Well I had some computer issues, but I pulled this shot from my garage computer.



My suspension goes like this,
23mm front 30mm rear T-bars
22mm front & rear sway bars Tarret
Von shocks street level 3 both front & rear, valved for the above T-bar sizes
Elephant racing full weld on bump steer kit
Front spindles raised 40mm
RSR front control arm bushing system
RSR rear spring plate bushing system
WEVO weld on rear sway bar mounts
Front strut tower brace
Fikse 5S wheels 17" x 8.5" front, 18" x 11" rears, 255-40's & 295-35's B.F.G. kdw2's
Hawk SPS front pads, Pagid black rear pads
Car weight 1/2 tank gas 2700 lbs. even

Alignment spec.'s,
corner balanced
-2.5 rear camber
-.9 front camber
front toe .06 deg each tire
rear toe .1 deg each tire
ride height real low, well below any normal persons taste

Hope this helps you guys out!

Mark
Old 05-18-2014, 02:05 PM
  Pelican Parts Technical Article Directory    Reply With Quote #14 (permalink)