View Single Post
DSPTurtle DSPTurtle is offline
Registered User
 
DSPTurtle's Avatar
 
Join Date: Jul 2001
Location: Suntree, Florida, USA
Posts: 2,206
Please take my comments in the interest of open source!!!
Have you run a sim that models the response rate of the W/B O2 against the dynamics of an engine spinning 4, 5 or 6k? MatLab could do this in a heartbeat. That's a lot cheaper than a $20k donor motor.
There's a reason guys spend a small fortune developing maps for efi. Granted, you're trying to go from a steady state of ~1.7bar to ~3.0bar based on some temp values. That sounds easy when you say it fast but... What happens when boost comes on? Can you get to 2.7bar fast enough to make sure we don't melt our extremely girly flat top pistons?
I sure hope so! I'll sign up for two units ASAP! Heck, I'd even be one of your test subjects if you need one.
Old 08-06-2014, 05:49 PM
  Pelican Parts Technical Article Directory    Reply With Quote #51 (permalink)