View Single Post
commdiver commdiver is offline
Registered User
 
commdiver's Avatar
 
Join Date: Oct 2007
Location: Northern, CA
Posts: 2,051
Garage
Wow they must have taken some of the meat off that area when grinding crank to lighten. I have a fresh 3 liter crank and 2.5 crank i will measure the distance between center of
#1 - #2 rod journals on both cranks and report back to try and get a reference for you.
In order for you to get this you might have to pull those 2 rod caps off and measure this but you could also look at rod bearings and journal size to confirm thise as well.

Also does it look like they used a turbo flywheel & clutch package with 951 bellhousing? It would throw the timing off just a few degrees because of more flywheel teeth but its been done, a good chip guy can buil that into maps. looks like a very cool build for sure thanks Eric

Last edited by commdiver; 02-15-2015 at 07:08 AM..
Old 02-15-2015, 07:04 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #13 (permalink)