View Single Post
350HP930 350HP930 is offline
Registered User
 
350HP930's Avatar
 
Join Date: Jun 2003
Location: St Petersburg, FL
Posts: 3,814
Rebuilding My 930

Well after 5 years of ownership and about 130,000 miles (70K of which are mine) I have recently dropped and broken down my 930 motor for a complete rebuild. I was hoping to put it off a bit longer but the starter ring gear lost a few teeth so the motor had to come out anyways. Its been needing a rering and reseal for a while.

Thanks to recent economic trends I will have to pull off my rebuild and mods on a tight budget. Fortunatley have access to a high end machince shop and porsche dealer service area due to my employment and engineering backgroud (BS in Aerospace Engineering, U of F, Class of 95) so I do not need to pay for anything but parts and dyno time.

Here is what I am planning on doing to extend my existing mods. I would appreciate any input people would like to give me on my project.

All the hardware looks beautiful except for a mild scratch in one cylinder. Everything mics to about 0.0005 of factory specs.

For this reason I am just going to rering the cylinders. I am seriously contemplating going with gapless rings.

Here is a list of most of the other stuff I have on my todo/toget list. (Updated 2/4/05)

ARP rod bolts and cylinder studs
All harware flycut and/or lapped and rods resized
New bearings and gaskets
New chains and tensioners
New valve guides and valve job
New performance cams, and rocker shaft seals
Slight compression bump
8:39 Ring & Pinion
Carrera Intake Manifold
Megasquirt II EFI
Distributorless Igntion
HKS EVC IV (Electronic Boost Controller)
Boring and Porting the Heads and Intake
Headers

My current spreadsheet for my project shows that the total cost for all this will about $8.5K.

I figure I have a few months before I will have all the time and money I need to pull this off. (As the thread shows I suffered from quite a bit of project creep from the 'while you are in there' phenomena)

I look forward to the wisdom this board is sure to bring me. (And it has brought me much since I started this thread)

Tony


Last edited by 350HP930; 02-06-2005 at 10:02 PM..
Old 06-19-2003, 07:04 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)