View Single Post
jwasbury jwasbury is offline
beancounter
 
jwasbury's Avatar
 
Join Date: Jan 2008
Location: Weehawken, NJ
Posts: 3,120
Quote:
Originally Posted by Jeff NJ View Post
You can see in this pic that that TOB collar was being pulled all the way out and touching the collar on the trans and left an impression in the grease, so any ideas of not enough throw, or misadjusted cables, levers, etc are out. The TOB cannot go any further.
Do you have the old pressure plate and TOB? If yes, I'd bolt it up to the flywheel and take some measurements to compare with your new parts. You could also bolt it up to the engine and work the release lever with a pry bar while watching the TOB through the inspection port. Then you could see if the TOB hits the trans like the new one.
Old 05-31-2015, 09:08 PM
  Pelican Parts Technical Article Directory    Reply With Quote #134 (permalink)