View Single Post
TurboKraft TurboKraft is offline
Registered User
TurboKraft's Avatar
Join Date: Mar 2005
Location: Phoenix, AZ
Posts: 2,542
Originally Posted by turbo owner View Post
I talked with the folks at Ollies today, seemed very knowledgeable but no EDM. The engine needs to come apart all the way to do the work, if the rods and crank need work I'll send everything there and he can sub the EDM work out.

So far most parts show little wear, tight valve guides and the valves look to have very few miles since being done. New seals and valve springs, hone the cylinders a touch and new rings then the top end will be about ready.

I'm planing to tear down the bottom this weekend and see what is inside.
LMK if TIG welding onto that stud doesn't work and you need EDM work done.
Chris Carroll
TurboKraft, Inc.
Tel. 480.969.0911
email: -
Old 08-04-2015, 10:20 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #49 (permalink)