Thread: 962 porsche
View Single Post
florio florio is offline
Join Date: Oct 2014
Location: Bordeaux, France
Posts: 275
+1 from me!

I'm so glad I followed your advice and took the chassis off of the rotisserie before installing the floor pans. I put it back on the mounting jig I had whipped up, and found a 7-8 mm gap with one of the front suspension points. A little tug and it came back nicely to 2mm. I know some have installed their floor with the car upside-down, and that it worked out for them, but I think I would have been off by that much more if I had not followed your advice, so THANK YOU!

Now, I will keep it on the jig while I weld in the rockers and rear quater panels. Then, if I read you right, I should move it to the suspension mounts to adjust the panel gaps.

good luck with book/racing

1972 S 911 Targa kit
Old 04-25-2016, 03:42 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #3 (permalink)