Fabspeed RSR
 

I purchased the Fabspeed RSR exhaust manifold and exhaust kit for my 1987 911 Carrera. The silicone tube doesn’t line up with the hole for the heater blower motor. It’s also difficult to fit the left and right heater boxes with this tube. Anyone else have this issue and what’s the solution?
Thx
Alan

I tried to download some photos but they didn’t post.

didn't they provide the under tin heat adaptor?

http://forums.pelicanparts.com/uploa...1677610905.JPG

I didn't get that piece. Can't tell how that adapts to the bottom side of the tin.

It just bolts on

pics of what you have might help

Have you tried calling Fabspeed? You paid them good money for the system....

Bill,

The 3.2 set up (vs your 3.6) is different. The current design has the heater tube pass through the tin this the same way the factory piece does...

Cheers