|
|
|
|
| Author |
|
|
Virginia Rocks!
Join Date: Oct 2003
Location: Just outside the beltway
Posts: 8,497
|
Welding and powdercoating??
To make along story short... I snapped off one of my targa bar studs when reinstalling the targa bar. I can't get it cinched down enough to get the philips screws in without the stud.
I have JB Welded the stud back on (not expecting a miracle). If I was to have a new stud welded on properly would that foul up the beautiful powdercoating job? Here's a photo to ponder while it dries....  
__________________
Rosewood 1983 911 SC Targa | Black 1990 944 S2 | White 1980 BMW R65 | Past: Crystal 1986 944 na Guards Red is for the Unoriginal
|
||
05-22-2005, 01:47 PM
|
|
|
Virginia Rocks!
Join Date: Oct 2003
Location: Just outside the beltway
Posts: 8,497
|
Wrong forum.... d'oh!
__________________
Rosewood 1983 911 SC Targa | Black 1990 944 S2 | White 1980 BMW R65 | Past: Crystal 1986 944 na Guards Red is for the Unoriginal
|
||
|
05-22-2005, 01:57 PM
|
|
|
Registered
Join Date: Mar 2003
Location: Oklahoma
Posts: 2,391
|
any time you weld you need to grind the area clean so yes it would mess it up in that area and further down depending on the heat and material etc
|
||
|
05-25-2005, 10:28 PM
|
|
