 
					|   | 
 | 
 | 
| 
 | 
| Registered Join Date: Nov 2005 Location: Cincinnati 
					Posts: 189
				 | 
				
				valve cover gasket replacement
			 
			I thought I might get a few more hits over here.... Do the valve cover gaskets only go on one way? The exhaust side gaskets appear to have a bead of silicone...and and I assume I should have the printed letters on the outside. In regards to the intake side...should the graphite side face outwards...? I can't seem to line up the intake gaskets with the print facing the outwards, so I assume the graphite side face outward.... 
				__________________ 86' 911 Carerra | ||
|  07-08-2006, 09:09 AM | 
 | 
| Registered Join Date: May 2003 
					Posts: 3,346
				 | 
			They will only go on one way. If you turned them over they wouldn't fit the bolt pattern or the pattern on the cam tower/valve cover.
		 
				__________________ 72 Carrera RS replica, Spec 911 racer | ||
|  07-08-2006, 04:30 PM | 
 | 
| Registered Join Date: Nov 2005 Location: Cincinnati 
					Posts: 189
				 | 
			Thanks Eagle...I went back to the garage after posting and looked at each orientation. I could see they only went one way, and that was good enough for me...thanks for the response.
		 
				__________________ 86' 911 Carerra Last edited by slotcar; 07-09-2006 at 05:21 PM.. | ||
|  07-08-2006, 06:08 PM | 
 |