![]() |
|
|
|
Registered
Join Date: Sep 2006
Posts: 8
|
![]()
I replaced my 901 trans with a 915 and need some help hooking up the electric speedo.
1. I have the round sensor that goes into the side of the trans and it has two wires coming from it, brown and green. 2. There is also a seperate single male connector coming off of the trans. 3. I have the electric speedo that has 4 male plugs across the bottom. 3 together and 1 offset by itself. Can anyone help me with where these wires go? I also need Intake manifolds and linkage to install the 40mm Zenith carbs I am replacing my MFI with. Thanks Howard |
||
![]() |
|
Registered
Join Date: Jan 2005
Location: KENDAL,CUMBRIA, UK
Posts: 1,580
|
HI as no one will tackle your bit of wiring I will , the 2 wires from the sensor on the gearbox you will have to run through to the dash , on the back of the speedo you will require a IGNITION live to the + terminal, earth on the _ (should be one of the old speedo) plus one of the wires from the gear box (also to earth on the same terminal) , the other wire from the gearbox is on to the 31b on the speedo , leave the other terminal.
regards mike |
||
![]() |
|