|
|
|
|
| Author |
|
|
Registered
Join Date: Nov 2008
Location: Michigan
Posts: 642
|
carb venturi's
I'm building some carbs right now. I'm going to make my own venturi's for my carbs. They are zeniths. I'm a machinist so I have everything i need to do it. I'm curious though about the taper in the venturi's. Do i have to hold that taper or isn't it that important.
|
||
12-31-2008, 01:39 PM
|
|
|
Registered
Join Date: Mar 2004
Location: So. Ca.
Posts: 521
|
Important
Delta p, Bernoulli effect etc. It tried years ago and unless I duplicated the Venturi design it would not take throttle. regards |
||
|
12-31-2008, 05:00 PM
|
|
|
Registered
Join Date: Mar 2007
Posts: 66
|
You can use Weber chokes (Venturis) and just make a spacer. I think it was 2mm.
__________________
Lotus 23 Lotus 7 TVR Vixen TR3 914-6 Clone 914-4 X-Runner |
||
|
01-01-2009, 05:41 AM
|
|
|
Registered
Join Date: Oct 1999
Location: Marietta, GA
Posts: 809
|
You need to have the smallest diameter at the opening of the venturi tube. The higher speed air in the restricted section will create a vacuum to draw the gas out of the venturi tube. I made 32mm chokes for my Zeniths. This is for a 2.0 liter racing engine.
|
||
|
01-01-2009, 06:51 AM
|
|
