Pelican Parts Forums
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   911 Engine Rebuilding Forum (http://forums.pelicanparts.com/911-engine-rebuilding-forum/)
-   -   Engine assembly tips... (http://forums.pelicanparts.com/911-engine-rebuilding-forum/984596-engine-assembly-tips.html)

ChrisBennet 03-15-2018 08:13 AM
KTL's tips are spot on: Here are few more:
  1. Clean the case perimeter holes to remove old Loctite. Otherwise old hardened Loctite "crumbs" inside the holes can break off and fall on the sealing surface when you assemble the case.
  2. If you use reusable rod bolts (like ARP), the machinist will need them when machining the rods. (They distort the rod end differently than the stock bolts.)
  3. Call me a heathen, but I never replace the distributor O-ring. I've never seen a leak there and using a new O-ring only makes it a pain to get the distributor in.

mike sampsel 08-05-2019 03:19 PM
Quote:
Originally Posted by Drbraunsr (Post 9960435)
Mark the tightening sequence of the case thru-bolts on the case with a Sharpie ( it wipes off easy with a little laquer thinner).

Buy (and use) Stomski's circlip injector tool. It's patented for a reason. I couldn't imagine installing the circlips without it.
Bingo on this sharpie idea! Gonna do it for my case redo! Thanks and I’ve borrowed the stomski clip installer.


All times are GMT -8. The time now is 10:46 AM.
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.