View Single Post
Reanimotion Reanimotion is offline
umop apisdn
 
Join Date: Jun 2014
Location: Brisbane, Australia
Posts: 441
The WUR curve looks good

If you intend to control spark then the green wire should be connected to VR1+ and VR1- on the microsquirt (pins 32 & 33)
http://www.msextra.com/doc/pdf/Microsquirt_Hardware-3.4.pdf
page 48 chapter 5.2.2 VR (magnetic) sensor input
Bosch CDI box control method will depend on the box, 3 pin should be easy, 6 pin will require some trickery and experimentation

for fuel only use, the green wire can be left connected to the CDI as is and the tachometer output of the CDI is then attached to OPTOIN+ and OPTOIN- should be grounded (pins 30 & 31)

There are variations on this if needed but the above are the standard configurations
__________________
Steve
1981 928S 4.7 ROW with KE3-Jetronic and Franken8 (AEM Inifinty) follow at [http://www.frankencis.com/Activity-Feed/userid/2]
Yes! mechanical/hydraulic constant flow injection can be managed by a modern EMS

www.FrankenCIS.com
Old 09-02-2016, 04:03 PM
  Pelican Parts Technical Article Directory    Reply With Quote #598 (permalink)