View Single Post
full quack full quack is offline
Registered User
 
full quack's Avatar
 
Join Date: Apr 2007
Location: Seattle-ish
Posts: 1,316
Send a message via Yahoo to full quack
Looking at the exploded view, it looks like #13's are the rubber grommets for sealing/supporting the throttle cable as it passes alone the pan tunnel. The #12 is the dust/water boot where the cable exits the pan, right above the torsion bar housing tube in the rear.

The pivot shaft bushings for the gas pedal assembly are #28 at the pedal assembly drawing.

The lowest drawing is from the transfer position at the tranny on the drivers side.

Mark
Old 12-01-2016, 03:05 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #5 (permalink)