View Single Post
boosted79 boosted79 is offline
Registered User
 
Join Date: Jan 2015
Posts: 1,263
OK thanks. I'll ask his opinion on welding the dog ring to the gear also. I read one thread where a couple guys said that after a new ring is pressed on it should be welded to the gear to prevent it backing off and CMS can do that. I can see where the gear was staked at the factory and where I could put a few TIG tacks, just wondering if this is really needed for a street car? I'll probably cut the old ring off in the lathe and then do the heat/freeze to install the new ring.
Old 01-27-2017, 03:57 PM
  Pelican Parts Technical Article Directory    Reply With Quote #117 (permalink)