View Single Post
jpilcher jpilcher is offline
Registered User
Join Date: Mar 2010
Location: Hamilton, On
Posts: 804
I plan on reworking rear relay and fuse panel.
I am adding a 10 fuse panel, controlled by a 40 amp relay. The relay will provide switched power to the fuse panel. The power will be supplied from the original harness pin 40. The fuse panel will supply power to coils, injectors, Boost controller, cam sensor, etc.
I will also be providing a ground terminal block
that will connect directly to the battery. I will use this to ground all the MS3 grounds, etc.
I will also be providing a terminal block for the sensor returns. This goes back to MS3.
I was also thinking of mounting the Electronic Boost Controllor.

Last edited by jpilcher; 06-06-2017 at 06:06 PM..
Old 06-06-2017, 06:01 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #177 (permalink)