View Single Post
boosted79 boosted79 is offline
Registered User
Join Date: Jan 2015
Posts: 1,337
pulley seal repair- speedi-sleeve

Finally got around to addressing the small leak I had at the pulley end of the engine after rebuild. I was sure it would be at the #8 bearing to case joint but it was the pulley seal. I pulled it and could find nothing wrong, it wasn't cut and the lip was fine. There was a visible wear mark on the crank but no groove that could be felt. So I installed a speedi-sleeve with some curil-t on the ID, put in a new seal and no more leak. Should have done the speedi sleeve on the initial assembly. The speedi-sleeve number for the 30 mm snout is 99114 if anyone needs one.

Last edited by boosted79; 09-01-2017 at 08:21 AM..
Old 09-01-2017, 08:08 AM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #1 (permalink)