View Single Post
db9146 db9146 is offline
Registered User
 
db9146's Avatar
 
Join Date: Dec 2004
Location: Atlanta, GA
Posts: 166
Garage
Since the photo I posted above, I decided to mount the EDIS module on the side wall of the 914-6 engine compartment under the battery tray. I did this to put some distance between the EDIS module and the coil pack. I also started with the wiring harness from a 6-cyl Ford so that I could use high quality connectors. As a benefit, I was able to use the VR shielded pair cable from the pickup back to the EDIS module (I found some stock replacement male pins for the Motorcraft connectors so I was able to shorten the Motorcraft harness and rewire the connectors). It actually came out quite well. I would recommend this approach.



If you start with a stock Ford harness, there will be a radio noise suppression cap that you'll want to include as well as a diode in the negative (ground) wire from Pin 9 of the EDIS connector to ground.

Last edited by db9146; 01-01-2018 at 08:17 PM..
Old 01-01-2018, 08:10 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #5 (permalink)