View Single Post
Trackrash Trackrash is offline
Under the radar
Trackrash's Avatar
Join Date: May 2007
Location: Sebastopol, the land of wine and redwoods in The Republic of California.
Posts: 5,240
Originally Posted by surfgod101 View Post
Thanks for the information Bruce

I have also 3.2 barrels & pistons but was concerned about the 40mm size of the PMO's, will they work but just make less power than 46's this is just a short term solution as vi may EFI it later on.

I also have a 2.4T long block so I could perhaps have this machined to take the 2.7 barrels & pistons. I am not worried about producing mega horsepower, just something useable for now

The 3.2 barrels will fit the SC case. The pistons won't work with the SC rods, however.

40 mm Webers will work fine on a motor up to 3,0L, unless you are wanting maximum top end power.

Are you trying to piece to together a motor from scratch? That could be an expensive proposition.
'71 911 Coupe 3,0L outlawed
#56 PCA Redwood Region, GGR, NASA, Speed SF
Trackrash's Garage :: My Garage
Old 02-05-2018, 02:42 PM
  Pelican Parts Catalog | Tech Articles | Promos & Specials    Reply With Quote #5 (permalink)