Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help

Go Back   Pelican Parts Technical BBS

MattNZ MattNZ is offline


Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. CamB
    11-08-2015 03:56 PM - permalink

    Sorry for slow reply - only just saw this (didn't get an email about it). Perhaps best to email me on if you need to.

    I did a project thread on it - did you see that?

    Hope that helps!

    I'd have a discussion with the anodiser - the less dipping the better I reckon. I don't 100% remember but it might have been necessary to get them dipped to remove the anodising as its not ok to anodise over old anodising. But avoid paint stripper dipping to get paint off. In fact, I could argue that mechanical stripping is safer full stop as I am pretty sure most paint stripper tries to attack most aluminium....


About Me

  • About MattNZ
    Tauranga, New Zealand


Total Posts
Visitor Messages
General Information
  • Last Activity: Yesterday 12:43 PM
  • Join Date: 10-04-2012

All times are GMT -8. The time now is 06:09 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2017 Pelican Parts LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.