Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Technical BBS > TurboKraft

Conversation Between TurboKraft and Jimmy18E
Showing Visitor Messages 1 to 3 of 3
  1. Jimmy18E
    09-09-2013 10:23 PM - permalink
    Jimmy18E
    My shop (KMW Motorsports) has an intercooler kit and injector blocks on order with you folks, thanks for the help with that..... My question/needs are a lightweight flywheel for the build. Do you sell a lightweight flywheel 240mm 6 bolt flywheel for my 77 3.0? Or do I need to send you my stock flywheel and you machine it?
    If you already have one machined in stock, do you give credit for my stock flywheel or need it for a core exchange?

    Thanks again!
    Jimmy
  2. TurboKraft
    09-04-2013 01:33 PM - permalink
    TurboKraft
    Hi Jimmy,
    Sorry I didn't see this message until now, it was marked "visitor."
    TurboKraft has done a few of those Ducktail ICs, but not enough to make a fixture and make them repeatably. Each car was custom, different than the car before.
    We can offer you a kit, as we have done with other clients around the world. This is $1850 including:
    * 2x cores, end tanks welded on
    * materials for center tank, approximate dimensions
    * tubing & couplers & clamps to make inlet & outlet tubes
    * materials for IC mounts
    Lead time is 2 weeks. They're special order and require payment upon ordering.
    Fabrication -- for the last two, we started with the same pkg listed above and were done in 7 hours
    Email us at info@turbokraft.com if you have other questions or would like to place an order.
    Best Regards,
    - Chris Carroll
    TurboKraft Inc.
    Tel. 480-969-0911
  3. Jimmy18E
    07-12-2013 10:53 PM - permalink
    Jimmy18E
    Sir,

    I sent you a PM earlier tonight, however I do not think it was delivered, not showing up in my sent PMs.

    I am interested in one of your intercoolers, the one that would fit under a duck tail or factory 3.0 turbo tail. It would be for 77 3.o turbo.

    I would prefer a completed intercooler, however you mentioned to me in a PM that you would rather send a intercooler kit. This would work, the shop I use is competent and could finish it out. My question is, how much and about how long to get one sent out once ordered?

    Thank you agin,

    Jimmy

All times are GMT -8. The time now is 08:09 PM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2017 Pelican Parts LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.