Pelican Parts Forums

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   MINI Discussion Forum (http://forums.pelicanparts.com/mini-discussion-forum/)
-   -   Question on Strut Tower Reinforcement Plate Install (http://forums.pelicanparts.com/mini-discussion-forum/773814-question-strut-tower-reinforcement-plate-install.html)

Nick (guest) 09-28-2013 07:40 AM
I just bought new strut mounts and I am installing them this weekend. Is it possible to compress the spring, use an impact driver on the 1 nut on the strut then the 3 nuts on the strut tower and replace the strut mount without any further disassembly? It looks liek there is enough room in figure 4 after lowering the assembly.

__________________
This post was auto-generated based upon a question asked on our tech article page here:

Nick at Pelican Parts 09-28-2013 07:40 AM
No, I would advise against it. You can easily mis-align something and end up worse off that before you started,

- Nick


All times are GMT -8. The time now is 10:25 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.