|
|
|
|
| Author |
|
|
Make Bruins Great Again
|
Need an adhesive for a badge on my grill cover.
Metal badge goes covering a hole in the metal gas grill cover. Easily gets to 450 degrees on a regular basis.
I was thinking about using JB Weld but wondered if the heat would be an issue. Tried it one but it fell off. I think I may have to get fresh tubes of the stuff. It came out a little thicker than usual and was tough to mix. Any suggestions on something better or just try again?
__________________
-------------------------------------- Joe See Porsche run. Run, Porsche, Run: `87 911 Carrera |
||
10-13-2021, 05:52 AM
|
|
|
Registered
Join Date: Sep 2009
Location: North of You
Posts: 9,160
|
DAP High Temp Silicone is good for 550...same as regular JB Weld.
JB Weld Exhaust Sealant is good for 850.
__________________
"A machine you build yourself is a vote for a different way of life. There are things you have to earn with your hands." |
||
|
10-13-2021, 06:41 AM
|
|
Max
