Has anyone play (yourself) with dish 30", 97w asia channels?

[rnln]

I read internet instruction and asked questions and tried it so many times, for 1/2 year, but still can't get the signal.
Currently I have the CS5000 with 110/119 all green. I know there is no channel available now but I do have the signal. I added the asian dish 30". Attached the dish500 LNB next to it and searched for 110 signal. I found it. Switch the cable to the dish30" LNB, then turn the dish slightly to the east, also turn the dish upward slightly.
1- On elevation, I play with elevation from the 110 channel up and down around 5 degree
2- on direction, I marked where I got 110 signal and turn the dish left and right between there for about 5mm either left or right. Still can't get any signal.
Anyone know any trick? Any thing I have to set on the receiver?
I currently have LNB Power: ON, everything else set to OFF.
Thanks.

[Scott R]

I have two dishes and switch for this reason, one for the 110, and one for the others.

[rnln]

do you have dish 30" for 97W?

[Jim Richards]

Do you know what the proper azimuth and elevation are to see the satellite from your location? Are there any obstructions in the path, such as trees, neighbors' houses, buildings, etc.?

[ErVikingo]

Can you educate me on FTA? What's the deal, what do you get and what do you need?

TIA !

[rnln]

Jim,
the only thing I see is several electricity lines a little below the path and is about 100+ feet or so in front of the dish.
Do you think this can be the problem? The thing is, these lines is ok for 110 and 119.

Juan,
you need a receiver, a dish set, and some cable. I hope from 97w satellite, I can get some free to air asia TV channels.

[bell]

don't these also have to be "clocked" in the correct position also with dual lnb's (i think that's what they're called) from reading your post you seem to indicate you only adjusted hor/vert.....

[rnln]

yes, only adjust horizontal and vertical. What else I should do? What do you mean by "clock" in the position?