Need Boxster measurements, please....
 

Lost my file on this job and a new customer wants a side graphic but their car is in the paint shop.

So a little help in measurements, please. Length of front fender wheel well to door, width of door and width of rear quarter panel, door to wheel well.

Thanks in advance.

http://forums.pelicanparts.com/uploa...1443805832.jpg

Yes, PINK wheels, Barbie car from Newport Beach. NOT MY ride.....:rolleyes:

I see that ride cruising the beach all the time. The wheels need a separate battery. VERY bright.

99 views and no one has a Boxster and a tape measure?:rolleyes:

Mike, nobody on this board has your experience and expertise at measuring large curves.

Perhaps Pat can volunteer to help you, so the measuring can be done with four hands. You and Pat could drive around LA looking for women driving Boxsters. Just hold up your measuring tape (soft, not hard) and ask if you can measure them. LA women will probably say, "You mean these? Let's go somewhere private."

It would be interesting to see their faces when you point to the car. :)

Rog

_

I can measure it up for you in the am ... Its cold, and dark out there now

I'll measure mine and post in a bit when I get back from running errands. Mine is an '08.

I assume this is what you're looking for.
http://forums.pelicanparts.com/uploa...1443882195.jpg

yup, thanks.....

I woke up and rolled out the door and forgot about you , sorry , it was still rainy and cold out there...

It's ok, mine is high and dry on the lift.....

7"
42.5"
17.5"

Measured about 1/2 way vertically between the vent and the groove in the body. (Approx the top stripe in your graphic)

Edit: I assumed you are going to make a little long and trim.... If you give me a height distance from the bottom of door, I can be more accurate.

Thanks.....