![]() |
I saw a sweet rig on my holidays, here's a pic. If I ever win the lottery I will buy this truck and the sad sack trailer behind it.
http://forums.pelicanparts.com/uploa...1469565356.jpg The moped in the back will have to go. I have no use for that thing. SmileWavy |
Dad had a '59 Boles Aero 24' tandem axle. It was all blond wood inside. Yours will look super when done, even if it turns a shade or two darker with oiling.
Good job. |
:)
|
Denis,
this may be too much information, and you may already know this, but,,, Take a deep breath. Make sure you want to do this.... I have done it three times. Once to just fix it up and go camping. Then another trailer and did it right. Then went back to the first one and did it right. (i should have just done it right the first time). I know of two airstreams in the area where the guys have just given up, too much work. one of the first steps is to make sure you stop all the leaks. these old trailers have them and they can be tough to find and stop. drop the bottom skins and look at the floor from the bottom side. you will get a much better picture of total floor rot. also you will see how much frame rot there is. there will be some - the fiberglass floor insulation falls down and collects water causing frame rot. floors typically rot under windows, access doors, wheel wells, and main door. the awning rail is also a frequent leak point. some guys end up pulling the body off the frame to get easier access to repair the frame and totally replace the floor. - i have not had to do this but some have. figure to replace the axles, they will be bad. inspect the frame at the axle location. the frame often cracks here if there is separation at the back. check for separation at the back - the frame is supported by the aluminum exterior, not the other way around. you can check by jumping on the back bumper and seeing if it drops downward separating from the back exterior panel. figure to replace everything - a/c, inverter, converter, battery, plumbing, window and door seals, refer, furnace, lights, beds, cushions, flooring. add a big D4 size truck battery and full led lighting. and add a current sensor to monitor amp draw so you know how much battery is left. don't rely on the voltage sensor, use a current sensor. If you try and fix up the old stuff they will just break down on you one at a time and drive you crazy with repairs and interruptions to your camping. if the camper does not have an a/c you can add one somewhat easily. it should be pre-wired including a drain tube. check the plastic exhaust shroud from the refer to the roof. they typically age-crack. you should add a decent size black tank, a grey tank, 40 gal capacity for each and plumbing. the older trailers had a small black tank only. you will need to space up the frame to make room for the tanks and enough drain pipe pitch to a macerator pump. don't go cheap and try to use a blue-boy portable tank, you will forever wish you had added proper size black and grey tanks. replace all the old copper piping with pex and put in a modern water pump. add a bypass around the (new) hot water tank to make it easy to winterize. while you are doing the plumbing, add tank level sensors and a read-out panel. careful when you replace the woodwork with new plywood, it adds weight quickly. Get a good weight distribution hitch with sway control. you don't need an F250 to pull these trailers. I use a tacoma or a jeep grand cherokee. these are fun trailers to rebuild but they are a big project. just psych yourself up and trudge thru it. Inland RV just south of Chino is a good resource. andy, the owner, is a crotchety old opinionated bastard but once you get past that he knows everything about airstreams. |
Yep. Restoring an old Airstream is a commitment in more ways than one. That's why around here a tiny 50 year old partially restored Bambi just sold for 30k!
|
Quote:
I'll look for the factor photos and put them in a flikr folder or similar. |
John, thanks for taking the time to write that. I don't have the time, (or really the inclination), to rebuild this thing from the ground up but I definitely need someone knowledgeable to inspect it and figure out what I'm working with. The good news is that so far, it's in remarkably good condition for its age and compared to other old ones I've seen online and in person. We have another 1950s 30 footer out at the ranch where I store it in SoCal, that one is a basket case project.
I haven't even tried to turn on the stove or inspect the water systems yet. Don't even know how to, I need the correct owners manual for it. I bought a reprint on eBay for what I thought would be a close enough year and model but everything is in a different location on mine. I have been able to inspect most of the floor from inside and so far it's all solid w the exception of the two spots right in front. I'll definitely get under it and check axles and frame, the axle, (it only has one), looks good from underneath. I paid a licensed trailer service repair place to inspect it before towing it to CA. in 2015 and they gave it a clean bill of health, plus serviced brakes/bearings/new tires. I just towed it back to MN. and it needs some further brake work. At any rate, I'll try to keep this thread going as I inspect different areas. Thanks again. :cool: |
Here's some shots of a custom one I worked on:
https://flic.kr/s/aHsjYc1z3A It was built as a lounge car for the beverage industry at trade shows etc. |
Quote:
|
Wow, vintage Airstreams came with a bathtub? Ridiculously cool! Unfortunately that sort of thing just doesn't fit into my life right now - no time. How cool would it be to go camping in that thing though?
|
The more I look at this, the more I'm thinking late model...and spend the rest of the money on Solar.
|
Looks like a nice project.
A friend of mine has a customized 1951 Royal Spartanette by the Spartan aircraft company. I had a chance to visit while it was being restored, left me in awe. I'm sure your end product will have similar results. |
Guess I'm the odd one. I really like the exterior of AS trailers but the interior is far too industrial looking and feeling for me. Like trying to call the dentist office home. Granted the craftsmanship of the older units looks phenonemal there is, IMO, no warmth or appeal. Guess I don't get it.
Love your thread Denis. Kudos for the effort, stripping cabinets is about the least favorite labor job I can imagine. ;) |
Quote:
Quote:
Looking good Dennis! |
Wish it was an RB, but this looks like a deal...
Flying_Cloud_Airstream/N515612 Interior*Like*New |
Quote:
I'm going for my usual color theme which is light but warm, cream/light beige, etc. :cool: |
Quote:
A person could totally live in that if they had a place to park it, plug in, etc. :cool: |
Quote:
Mint older ones are $$ and new ones are $$$$$, the one that Sid posted looks like a winner if you want a trailer. :) |
Quote:
|
Here is the thread on mine,
http://forums.pelicanparts.com/off-topic-discussions/501834-bought-old-travel-trailer.html Unfortunately it was totaled in a hail storm. After I spent quite a bit of time polishing the exterior of coarse. I bought it back from the insurance company and just sold it. After all the work I put into it the hail dents bothered me to much. |
All times are GMT -8. The time now is 10:06 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website