|
|
|
|
| Author |
|
|
Registered
|
Head light switch
On this 76 911 I am putting in a new turn signal indicator. I have dropped the head light switch in order to make it easier to connect the wires from the new turn switch. When I pulled it from the back of the dash there are two wires I believe got disconnected. I have done nothing yet with the wiring as I want to go slowly and not get anything mismatched.
I would like to know if the wire, in the picture, with brass, L connector (white with black strip wire) and the short wire, (in the middle of the pic.) belong together and need to be connected to the bare pole on the switch #56? 
__________________
66 Shelby Hertz Renta-Racer 68 Shelby 500KR 78 Ferrrari 308 16 Macan S 11 Speedster Last edited by bcgreen; 05-04-2020 at 11:34 AM.. |
||
05-04-2020, 10:44 AM
|
|
|
Registered
|
__________________
1985 911 with original 501 708 miles...807 421 km "The difference between genius and stupidity is that, genius has its limits". Albert Einstein. |
||
|
05-04-2020, 11:25 AM
|
|
|
Registered
|
Quote:
__________________
66 Shelby Hertz Renta-Racer 68 Shelby 500KR 78 Ferrrari 308 16 Macan S 11 Speedster |
||
|
05-04-2020, 11:32 AM
|
|
|
Registered
|
just read the colors;-) how otherwise you would like to be helped???
1st picture is your guide... ivan
__________________
1985 911 with original 501 708 miles...807 421 km "The difference between genius and stupidity is that, genius has its limits". Albert Einstein. |
||
|
05-04-2020, 11:35 AM
|
|
