The 3.2 rebuild is almost complete......
 

This is what I did today.......I rebuilt the 3.2 engine (spun rod bearing) and today installed it back into the 911......I just need to wire it up and refurb/repair the oil cooler/lines etc and it will be ready to roll!!.....he said confidently.


http://forums.pelicanparts.com/uploa...1653524235.JPG
http://forums.pelicanparts.com/uploa...1653524235.JPG

regards,
al

Hey Al, did you get the crank reground or source a good used one? Nice job btw.

Thanks...the answer is yes. I found a nice used one and that is installed and the original crank was sent to Marine Crankshaft for repair. Once it is done, it will be up for sale...so , if you know anyone looking for a reworked 3.2 crank...send them my way.

regards,
al

nice but how about the engine sound proof?

Ivan

1st fire today.....
 

The 3.2 is alive!!!!!!!



<iframe width="961" height="721" src="https://www.youtube.com/embed/NFM7fBVlWq4" title="YouTube video player" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>

sounds great ..good job

Ivan

You don't need no stinkin sound proof.. :D

well, in that case just get the sound proof which does not stink;-))))

I get it, some people like them some don`t

Ivan

On a 3.2 I'm working on, the lower rear airbox clip has been broken.. I've seen a few like this as it's the most difficult clip to reach ....

Owner is thinking of a cone filter setup.. where do we get the adapter place to mount a cone filter to the maf?

Mike

Mike,
I'm not sure who provides these...AJ USA maybe?

regards,
al